Dashboard trim installation 

Difficulty level 7,5/10

Removing steering column 

If you are going to do the installation without removing the trim pieces, it is recommended to at least remove the top of the steering column. This way you get better acces to the sides of the panels.

1: Unscrew the bottom.

2: Use the plastic tool to pry the panels apart.

3: Loosen the top piece.

4: Pull the panel towards you and place it upwards (out of the way).

5: If necessary, you can also detach the bottom panel.

6: Turn the steering wheel until you can reach the 2 screws (left and right).

TIP: Putting the steering wheel in a different position can give you more work space.

Installation Mirror Trim

Difficulty level 4/10

You can easily remove the mirror covers from the car by pulling them towards you by hand or with a trim tool.

Degrease well before you start the installation!!

1: There is approximately 6mm overlap around the panel, so you can wrap the edges.

2: Remove the protective film.

3: Try to keep the edge as parallel as possible at about 6mm.

4: Continue rolling the piece onto the foil.

5-6: Now push the foil into the curve (without tension).

7--->12: Cut the corners as shown.

13: Fold the wrap inwards.

14: Install the trim.

Rear Door Trim installation 

Difficulty level 3/10

See mirror trim installation.

Tailgate Trim installation

Difficulty level 3,5/10

Simply line up the edges so you have about 8mm on each side and press down!

Door Inlay installation

Difficulty level 10/10

UPDATE: They now come in 1 piece and are slightly oversized on both the inside & outside so you can cut the excess with the provided scalpel. This is less time consuming and gives better results. Starting point remains the same, only now you have a 10mm overlap on the inside.

• Interior cleaners are NOT for prepping the surface. Use the provided surface cleaner.

• Spray adhesive can be used for better adhesion.

• Don't let the material stick to itself !!!

Rear doors starting point.

Armrest Inlay installation 

Difficulty level 2/10

Fold about 2-3cm from the backing paper and line up the corners.

Remove the backing paper completely and lay down the rest of the wrap.

Gear Surround installation

Difficulty level 6,5/10

The side pieces line up against the edge of the top piece. Start with the wide part and work your way down to the small edges.